Subject: Problems with 2520 losing Z axis position Tue Sep 28, 2010 10:21 am
My 2520 has started acting up after a month. It loses Z position randomly, always going down too far. I need suggestions for a fix as this is starting to get very frustrating. I've lost several pieces recently. I am cutting machinable polypropylene using an 1/8" end mill. I use a spindle feedrate of 100 mm/min. I use Meshcam to generate toolpaths.
cncdiy Admin
Posts : 45 Join date : 2010-01-13
Subject: Re: Problems with 2520 losing Z axis position Sat Oct 09, 2010 12:44 pm
The problem has been solved?
jt123goo
Posts : 3 Join date : 2010-09-28
Subject: Re: Problems with 2520 losing Z axis position Tue Oct 12, 2010 6:32 am
No. I spoke to someone via Skype and am waiting for a new controller board that is being sent via Air Mail.
cncdiy Admin
Posts : 45 Join date : 2010-01-13
Subject: Re: Problems with 2520 losing Z axis position Tue Oct 12, 2010 9:07 am
Please contact Walter again!
cncdiy Admin
Posts : 45 Join date : 2010-01-13
Subject: Re: Problems with 2520 losing Z axis position Tue Oct 12, 2010 9:40 am
Please try to connect the machine with the "Earth" of the electrical power system.
jt123goo
Posts : 3 Join date : 2010-09-28
Subject: Earth? Mon Oct 18, 2010 12:56 pm
Connect what to earth/ground? A pin on the controller?
Sponsored content
Subject: Re: Problems with 2520 losing Z axis position
Subject: Problems with 2520 losing Z axis position 
Tue Sep 28, 2010 10:21 am